Buy it on Luxonis shop


The OAK-FFC-OV9282 is a carrier board for the Arducam PY010 OV9282 camera module. A 26-pin FFC is used to carry 5V power, 2-lane MIPI, I2C, and other control signals between this camera module and the controller baseboard.

This OAK FFC module is compatible with any OAK FFC baseboard:

People typically use a pair (2) of OAK-FFC-OV9282 to create a stereo camera pair. We previously used Sunny TG161B or AN01V32 OV9282 camera module.

Hardware specifications

Camera module specifications

Camera Specs

Stereo pair


OV9282 (PY003)


89° / 80° / 55°


1MP (1280x800)


Fixed-Focus: 19.6cm - ∞

Max Framerate

120 FPS


2.0 ±5%

Lens size

1/4 inch

Effective Focal Length


Pixel size

3µm x 3µm


  • Width: 25 mm

  • Height: 24 mm

General information

  • 26 pin 0.5mm FFC interconnect to baseboard

  • 24 pin interface to OV9282 camera module

  • 2-lane MIPI

  • Aux/Control signals to camera module

  • 5V power input via FFC

  • On-board power generation for camera module

  • Design files produced with Altium Designer 20

Getting started

Camera module compatibility is known for the Arducam PY010 OV9282 and previously used Sunny TG161B and AN01V32, but not tested for other modules. The FFC interface is an 0.5mm pitch, 26-pin, and bottom-contact connector, across which travels the 2-lane MIPI, 5V, I2C, camera clock, camera reset, and other optional control lines. 5V power is regulated down and filtered as appropriate to meet the requirements of the compact camera module and OV9282.

3D Models

  • Board STEP files here


Got questions?

Head over to Discussion Forum for technical support or any other questions you might have.